E-4
(12) Remove the cover from the main unit as shown
in the illustration. (One screw)
(13) Remove the knockout from the cover removed
in step (12) with nippers.
(14) Remove the paper backing from the supplied
film and attach it to the main unit as shown in
the illustration.
Note:
• Alignment in vertical direction:
Align the lower edge of the film with the surface
of the cover in the exit section.
• Alignment in back and forth direction:
± 2 mm from both edge of the depression on
the cover of the exit section
(15) Attach the supplied sensor unit to the main unit
by fitting the two tabs into the holes.
(16) Secure the sensor unit with the supplied
screw A.
(17) Conduct the following procedure to connect the
sensor unit's connector to the main unit.
<C554e/C454e/C364e/C284e/C224e/C554/C454/
C364/C284/C224/554e/454e/364e/284e/224e>
a) Remove the connector from the wire saddle
shown in the illustration.
± 2 mm
Connector
Wire saddle
