7
EN
PUNCH G2
C.
Paper Clearing:
When paper is jammed in the paper path of
PUNCH G2 the LCD display shows the area
where a sheet(s) is jammed.
Area
Description
Zone 1
If paper is jammed in Zone 1, lift the paper guide
plate located just inside, reach and remove the
jammed paper. To close the paper guide, raise
the handle to unlatch the mechanism and firmly
close it.
Zone 2
If paper is jammed in the downward paper chute,
move the chute to the right, reach in and remove
the jammed paper.
Ensure the paper chute is closed.
Zone 3
If paper is jammed in the right bottom chute, press
the top lever while holding the bottom lever. This
will unlatch the chute; continue to open the chute
until it reached the magnet on the right side. Reach
in and remove the paper. To return the chute to the
closed position, move it back in the opposite
direction until the latch mechanism is activated.
Ensure the paper chute is closed.
Zone 5
If paper is jammed in the left bottom chute,
unlatch the chute, reach in and remove any
jammed paper.
Ensure the paper chute is closed.
Zone 6
If paper is jammed in the upward paper chute,
move the door to the left, reach in and remove the
jammed paper.
Ensure the paper chute is closed.
Zones 3 and 5
Before uninstalling the die set, ensure zone 3 and
5 are cleared of any jammed paper. If there is
jammed paper that cannot be removed from
zones 3 and 5, uninstall the die set to remove the
jammed paper. (see Section 4. Changing the
Interchangable die sets).
5. USER DISPLAY
. OPERATION CONTROLS
Located on the front of the PUNCH G2 is a user interactive LCD panel
that provides Messages; Settings and Information relating to the
functions of the punch unit.
LCD Panel Overview
Messages on the LCD Panel
1.
Ready Bypass
PUNCH G2 is ready to bypass, sheets will not be punched.
2.
Ready Single Punch
PUNCH G2 is ready to process a punch job, all sheets through the
unit will be punched.
3. Ready Double Punch
PUNCH G2 is ready to process a punch job, all sheets through the
unit will be punch in the middle of sheet and along trail edge of the
sheet.
4.
Running Bypass
This is displayed when Bypass mode is in operation.
5.
Running Single Punch
This is displayed when Single punch mode is in operation.
6.
Running Double punch
This is displayed when Double punch mode is in operation.
7.
Chip tray Full
When the punch container becomes full of waste paper chips, this
message will be displayed.
8.
Chip tray Out
When the punch container is removed or not fully inserted into the
punch unit, this message will be displayed.
9.
Check die
When the Die Set is removed or not fully inserted into the punch
unit, this message will be displayed. When this message is
displayed the punch unit will run in Bypass mode only.
10. Close Door
When the Front door is open or not completely closed this
message will be displayed.
11. Paper jam
When a sheet of paper becomes jammed within the punch unit,
this message is displayed. See the section of this manual titled
PAPER CLEARING for instructions on how to remove a jammed
sheet.
LCD User Interface Screen Overview
MAIN SCREEN
SETTINGS
INFORMATION
BACKGAGE
ALIGNMENT
CLEAR COVER
LANGUAGE
UNITS
DIE
TYPE
DIE
CYCLES
PUNCH
CYCLES
Options:
TRAIL
MID L
MID XL
Options:
CC BACKGAGE
CC ALIGMENT
Options:
DEUTSCH
ENGLISH
ESPANOL
FRANCAIS
ITALIANO
Options:
MM
IN
FIRMWARE
