E-6
(2) Remove the rear left cover of the finisher
(three screws).
(3) Remove the rear lower cover of the finisher
(seven screws).
(4) Adjust the height of the front and rear casters
located on the paper exit side of the finisher to
ensure an appropriate gap between the front
door of the finisher and the machine.
18. Insert upper exit tray into the sub tray paper exit
slot on the finisher.
Note:
When installing upper exit tray, push the tray all
the way in until you hear a click.
19. Install the lower exit try furnished with the fin-
isher to the up/down section of the finisher (two
screws C’s furnished with the finisher).
Note:
When installing the lower exit tray, hook the guide
holes of the lower exit tray over the four mounting
clamps and then fix it.
20. Connect the hookup cord of the horizontal trans-
port unit to the machine.
A07UIXC018DB
A07PIXC007DA
A07PIXC008DA
A07PIXC004DA
A07UIXC062DA
A07UIXC023DA
