E-5
14. Connect the three finisher connectors to the
connectors located on the rear left side of the
machine.
15. Install the finisher on the machine.
Note:
Align the hook portions of the mounting bracket A
and the mounting bracket B with the upper and
lower holes in the finisher. Then, push the finisher
toward the rear.
16. Open the front door of the finisher and secure
the finisher to the machine (two mounting
screws furnished with the finisher).
17. Insert five to six sheets of paper into the gap
between the front door of the finisher and the
machine and move the sheets up and down to
check to see that they are not caught on either
side of the devices.
* When the sheets are caught on either of the
sides, carry out the following steps (1) to (4).
(1) Remove the rear right cover of the finisher
(six screws).
Note:
Only the screw
➀
is different from other screws.
Be sure to use the screw
➀
on the same place
when attaching the rear right cover.
A07UIXC013DA
A07UIXC014DB
A07UIXC015DB
A07UIXC016DB
A07UIXC083DA
A07PIXC003DA
➀
