23
WARNING
Do not use the CM-3700A in places where flammable or combustible gases (gasoline fumes, etc.)
are present. Doing so may cause a fire.
Do not disassemble or modify the CM-3700A. Doing so may cause a fire or electric shock.
The CM-3700A should not be operated if it is damaged, or smoke or strange odors occur. Doing so
may result in a fire.
In such situations, turn the power OFF immediately, disconnect the AC adapter from
the AC outlet, and contact the nearest Konica Minolta-authorized service facility.
CAUTION
Do not perform measurement with the specimen measuring port directed
towards your face. Doing so may cause damage to your eyes.
Be careful around openings in the CM-3700A. Failure to do so
may result in fingers being trapped causing injury.
Setting a Specimen
Reflectance measurement
{
Make sure that there is nothing in the transmittance chamber.
{
Before starting reflectance measurements, attach the target mask to be used for measurements.
{
Before starting reflectance measurements, set the measurement area, specular component, and UV light
quantity using the software.
1.
Pull the sample holder toward you and keep it
open.
c
The sample holder will remain open when
it is opened more than 70 degrees.
2.
Secure the specimen with the sample holder.
3.
Slide the measurement port baseplate
lock in the direction of the arrow, open
the measurement port baseplate, and
check the position of the specimen.
{
Hold the measurement port baseplate when
sliding the measurement port baseplate lock to
keep it from falling open.
{
Do not apply strong pressure to the measurement
port baseplate when the measurement port
baseplate is open.
{
The measurement cannot be performed when
the measurement port baseplate is open.
Check the
position of the
specimen
