Security Function Ver. 1.02 Mar. 2016
11. FAX function
43
11. FAX function
NOTE
• When the user use the machine with the facsimile function, it is necessary to
install and setting the optional FAX kit FK-513 properly by the service engineer.
11.1 Installing/setting procedure of the FAX kit
11.1.1
Install procedure
1.
Turn OFF the power switch and unplug the power cord from the power outlet.
2.
Remove the left rear cover from the machine. (Three screws)
3.
Remove the toner filter at the back side of the machine and remove the rear cover. (13
screws)
4.
Attach the supplied wire saddles. (Two supplied wire saddles)
5.
Attach the Fax kit. (Two supplied screws)
Insert the protrusion of the Fax kit into the slot of the machine.
Attach the Fax kit while pushing it to the right side.
6.
Route the supplied harness through the wire saddles installed in step 4 and insert the
connector into the Fax kit.
Make sure that the white cable tie securing the harness is positioned between the wire
saddles.
7.
Route the harness inside the edge cover and insert the connector into the MFP board.
8.
Connect the supplied USB cable to the Fax kit at the port of the MFP board and route
the cable through the two wire saddles.
9.
Install the rear cover and install the toner filter.
10.
Remove the knockout from the left rear cover removed in step 2 using nippers.
11.
Attach the left rear cover. (Three screws)
11.1.2
Installation of the ferrite core
Perform the steps only when a Fax Kit which has a ferrite core bundled for applicable mar-
keting area is installed.
If the telephone is not connected to the main unit, keep the ferrite core in a safe place.
1.
Attach the supplied ferrite core to the modular cable of the telephone.
Install the ferrite core by winding the cable two turns.
Attach the ferrite core at the position same as where a ferrite core has been attached
on the supplied modular cable.
2.
Connect the modular cable of the telephone to the TEL port.
Connect the jack on the end near the ferrite core to the Fax kit.
11.1.3
Connecting the modular cable
1.
Connect the supplied modular cable to the LINE port.
Connect the jack on the end near the ferrite core to the Fax kit.
Only analog circuits are allowed for users connecting to the Key Telephone System or
private branch exchanges (PBX).
2.
Attach the supplied clamps on the upper and lower sides of the ferrite cores and secure
them on the back side of the machine.
11.1.4
Affixing the labels
1.
Affix the supplied label.
2.
Affix the supplied label (Super G3 label).
