Konica Minolta AU-211P, User Manual, Page: 51 / 52

5.1 Product Specifications 5
AU-211P 5-2
5 Appendix
5.1 Product Specifications
5.2 Cleaning the Authentication Unit
Wipe the surface using a soft, dry cloth. If the surface is still dirty, moisten a cloth with mild detergent and
thoroughly wring it out before cleaning. Once the dirt has been removed, moisten a cloth with water, thor-
oughly wring it out, and wipe off the detergent.
Tips
- Remove this unit from the MFP before cleaning. Loading the USB port will result in a malfunction.
-
Take care so that no water gets into this unit when cleaning. If water gets into this unit, it will result in a
malfunction.
-
Do not clean this unit using organic solvent such as benzene or alcohol. Doing so will result in a mal-
function.
-
Before disconnecting or connecting this unit, turn the MFP Main Power off. After 10 seconds or more
have lapsed, turn the MFP Main Power on. Failing to do so may result in a malfunction.
- When connecting or disconnecting the USB cable, hold the plug. Failing to do so will result in a mal-
function.
5.3 Troubleshooting
If an error occurs during running, refer to the following.
If any of the above errors recur after taking the specified action, or if other errors occur, contact your service
representative.
Item Specifications
Product name Authentication unit (PKI-IC card type) AU-211P
Dimensions 70 mm (L) e 70 mm (W) e 10 mm (H)
Weight 60 g
Power supply USB bus power
Range of operating temper-
ature 0 to 50°C
Interface Full speed USB (12 Mbps)
Connector shape USB A type connector
Compatible card PKI-IC card (PIV, CAC)
Status Point to be checked Action
Failed in login. Did you enter the correct
PIN code? Check the PIN code, and enter the correct one.
Cannot log in. Is the PKI card locked? If the number of authentication failures reaches
a specific limit, the PKI card will be locked to
prevent the authentication. For details on how
to unlock the PKI card, contact the PKI card
administrator.
The MFP does not re-
spond even though the
PKI card is inserted. Did you restart the MFP
after connecting this unit
to the MFP? Turn the MFP Main Power off, disconnect the
USB cable from either the MFP or this unit
once, and connect it again. Wait at least 10
seconds, and turn the MFP Main Power on.