Maintenance
20220752H
41
8.4 Return for Service
Please ensure that an instrument that is believed to be faulty is
correctly installed, the wiring is in good condition and correct,
that all connections are secure, and that a correct supply is
present at it’s Roblink/power connector.
Should the unit have to be returned to your dealer, adequate
packing must be used. Please ensure that your name, telephone
number, return address, a clear fault description, and if possible
a copy of the receipt of purchase are included with any
returned equipment. Simrad and their representatives are not
responsible for any equipment lost in transit.
Please quote the instrument’s serial number in all
correspondence. This may be found on the rear of the
instrument.
8.5 Local Master Reset
When an instrument is leaving the factory a Master Reset has
been made. However, if an instrument is being used in a
different system or setup, you can perform a local Master Reset
on the instrument in that system before you disconnect it and
move it to a system where you want to put it.
Refer to screen 7 on page 35.
1.
Turn off the Roblink as per instructions
2.
Perform a Master Reset as per instructions
3.
Turn on the Roblink as per instructions
You can now install the instrument in another system without
having to make a system wide Master Reset and loose the
existing calibration and settings in that system.
