Installation
20220752H
23
Use the Roblink Power Cable (P/N 22093587) for supply to
connector no. 1. Cut off one of the plugs on the supplied 0,3 m
(1’) cable and extend it to the NMEA source using twisted pair
cable. Use connector no. 4 for NMEA connection (see Figure
5-9). Connect the Wind Transducer to no. 3 connector (sensor).
Notes !
1.
If one or two more instruments are added to the above system the
Wind Transducer must be connected to the no. 2 connector on the
last instrument in the chain.
2.
The above system needs speed input on NMEA 0183 format to
display True Wind angle and speed. To display wind direction also
heading input is required together with speed from the same source,
e.g. a GPS with SOG and COG output. Alternatively speed and
heading may come from separate sources. Then a second head must
be added for interfacing.
3.
When connected to an IS15 Tri-data system as shown on Figure
5-4 speed is available on Roblink format and heading on NMEA
format.
Integrated systems
Speed/temp
transducer
Depth
transducer
Supply 10,8-15,6VDC
SIMRAD
IS15 Combi/Multi
10 m (33')
10 m (33')
10 m (33')
IS15
Transceiver
SIMRAD
0,3 m (1')
IS15 Combi/Multi
Wind
Transducer
IS15 Wind
SIMRAD
Junction box (mast foot)
0,3 m (1')
10 m (33')
30 m (99')
From Autopilot
(NMEA)
Stand alone
compass
NMEA
To Autopilot
(NMEA)
NOTE:
The wind transducer should be
connected to the Transceiver unit.
NOTE:
Cables are not shown
in connected order.
Circuit breaker
Optional
third
instrument
*
*
*
*
**
**
Denotes Roblink
cable with connector
Optional extra cable
*
**
Figure 5-4 IS15 Wind – IS15 Combi (Tri-data) System layout
