Kongsberg RADius 1000, Installation Manual

Page: 37 / 64

RADius 1000 Installation Manual, rev. 5 Installation
27
3.4.3 Setup of configuration parameters
Configuration parameter setup consists of:
•
Select Interrogator Unit (see chapter 3.4.3.1)
•
Entering the mounting angle for the Interrogator Unit (see chapter 3.4.3.2)
•
Entering output data interface (see chapter 3.4.3.3)
Figure 20 System Configuration dialog box
Always fill in the setup parameters for the specific installation in the Installation Worksheet
before entering the setup software. Fill in the parameters directly in the worksheet found in
the
Appendix A - Installation worksheet in the manual. In this way, the parameters for the
actual installation will be easier to find when requested later.
3.4.3.1 Select Interrogator Unit
During first boot after installation, it is necessary to select which Interrogator Unit to use.
This is done by selecting the button in the Radius GUI. This will open the window
shown in Figure 20. By selecting View Interrogator Units , a list of current Interrogators
appears (as in Figure 21).