Komatsu PC490-11, Installation And Instruction Manual

Page: 395 / 492

If the rubber hose is cracked or become fragile, ask your Komatsu distributor for replacement.
If the hose clamp is loose, tighten it.
7.
Remove undercover (10) and blow out the mud, dirt, and
leaves to the outside.
8.
Push in cleaned net (3) back to the original place and in-
stall it with screw (2).
9.
Install bracket (5) with bolt (4).
10. Install cover (1) and undercover (10).
METHOD FOR CLEANING AIR CONDITIONER FRESH/RECIRC FILTERS
k k
WARNING
When using compressed air, there is a danger that dirt may scatter and cause personal injury. Always
wear protective equipment such as protective eyeglasses and dust mask.
NOTICE
The cleaning interval of 500 hours is a rough standard. Clean at shorter intervals in dusty jobsites.
REMARK
If the element becomes clogged, the air flow will be reduced, and there will be a rumbling sound from the air
conditioner unit.
METHOD FOR CLEANING RECIRCULATION AIR FILTER
1.
Remove wing bolts (1) from the inspection window at the
bottom rear left inside the operator's cab.
2.
Take out the recirculation air filter.
3.
Clean the filter with compressed air.
If there is oil on the filter, or if the filter is extremely dirty,
wash it in a neutral detergent. After rinsing it in water, dry it
thoroughly before using it again.
Replace the filter with a new one every year. If the clog-
ging of the filter cannot be removed by blowing with air or
washing in water, replace the filter immediately.
REMARK
• The recirculation air filter must be installed in the correct direction.
• Install the filter so that protrusion (A) of filter (2) matches the groove of holder (3).
4.
Install the recirculation air filter.
METHOD FOR CLEANING FRESH AIR FILTER
1.
Unlock cover (4) at the rear left of the operator's cab with the starting switch key.
MAINTENANCE MAINTENANCE PROCEDURE
4-55