Komatsu 830E-AC, Shop Manual

Page: 21 / 1085

A03030 3/06 General Safety and Operating Instructions A3-7
Mirrors, Windows, And Lights
• Remove any dirt from the surface of the
windshield, cab windows, mirrors and lights.
Good visibility may prevent an accident.
• Adjust the mirrors to a position where the
operator can see best from the operator's seat.
• Ensure headlights, work lights and taillights are in
proper working order. Ensure that the machine is
equipped with the proper work lamps needed for
the operating conditions.
• Replace any broken mirrors, windows or lights.
In The Operator’s Cab - Before Starting The
Engine
• DO NOT leave tools or spare parts lying around
or allow trash to accumulate in the cab of the
truck. Keep all unauthorized reading material out
of the truck cab.
• Keep the cab floor, controls, steps, and handrails
free of oil, grease, snow, and excess dirt.
• Check the seat belt, buckle and hardware for
damage or wear. Replace any worn or damaged
parts. Always use the seat belts when operating
a machine.
• Read and understand the contents of the
Operation & Maintenance manual. Read safety
and operating instructions with special attention.
Become thoroughly acquainted with all gauges,
instruments and controls before attempting
operation of the truck.
• Read and understand the WARNING and
CAUTION decals in the operator's cab.
• Ensure the steering wheel, horn, controls and
pedals are free of any oil, grease or mud.
• Check operation of the windshield wiper,
condition of wiper blades, and check the washer
fluid reservoir level.
• Be familiar with all steering and brake system
controls, warning devices, road speeds and
loading capabilities, before operating the truck.
OPERATING THE MACHINE
Starting The Engine
• NEVER ATTEMPT TO START THE MACHINE
BY SHORTING ACROSS THE STARTER
TERMINALS. This may cause fire, or serious
injury or death to anyone in machine’s path.
• NEVER start the engine if a warning tag has
been attached to the controls.
• When starting the engine, sound the horn as an
alert.
• Start and operate the machine only while seated
in the operator’s seat.
• DO NOT allow any unauthorized persons in the
operator's compartment or any other place on
the machine.
Truck Operation - General
• WEAR SEAT BELTS AT ALL TIMES.
• Only authorized persons are allowed to ride in
the truck. Passengers must be in the cab and
belted in the passenger seat.
• DO NOT allow anyone to ride on the decks or on
the steps of the truck.
• DO NOT allow anyone to get on or off the truck
while it is in motion.
• DO NOT move the truck in or out of a building
without a signal person present.
• Know and obey hand signal communications
between the operator and spotter. When other
machines and personnel are present, the
operator should move in and out of buildings,
loading areas and through traffic, under the
direction of a signal person. Courtesy at all
times is a safety precaution!
• Immediately report any adverse conditions on
haul road, pit or dump area that may cause an
operating hazard.