Vers. 280519
6
3) Cycles - Number of total screwing/errors done which have been carried out: It shows the number of
fastened screws and occurred errors. This
number can’t be modified.
4) Change password: You can change password (see point 5).
5) Password: If YES, you will be asked for the password to enter the menu. Otherwise select NO.
ATTENTION: Password is only asked to enter the menu for the first time after switching the unit on.
The default password is: 0000.
6) Press OK: when ON, press OK at the end of each screwing.
When OFF, the control unit resets automatically after a screwing.
7) Press ESC: when ON, press ESC to reset the control unit.
When OFF, the control unit resets automatically after an error signal.
INTERPRETATION OF ACOUSTIC SIGNALS
The control unit emits sounds which help you understand if the screwing has been carried out correctly or
not. When the torque is reached meeting all the parameters set, the control unit utters a 0.5 sec beep as
confirmation. In case of Program End, the unit will utter other two beeps. Instead, torque reached under min
time, during the Ramp time or under the Fast speed (see error signals on the display) will cause the control
unit to utter three beep sounds.
- - - - O P T I O N S - M E N U - - - -
3 ) C y c l e s :
0 0 0 0 0 0 0 0 0
4 ) C h a n g e
p a s s w o r d
5 ) P a s s w o r d
- - - - O P T I O N S - M E N U - - - -
6 ) P r e s s
O K :
o f f
7 ) P r e s s
E S C :
o f f
