Kolpin 1466 Product Instructions Download

Page: 5 / 6

REV 01

SPECIFIED FASTENER TORQUE:

7 ft. lbs. (84 in-lb) (9.5 Nm)

9. Insert one 1.6mm Thick Clamp Spacer [Item 5] into each of the 2.00 Diameter Clamps [Item 4] on the Upper Panel. See Illustra-

tion 1-6.

10. Insert one 1.6mm Thick Clamp Spacer [Item 5]

AND

one 4.6mm Thick Clamp Spacer [Item 6] into each of the 1.75 Diameter

Clamps [Item 3] on the Upper Panel. See Illustration 1-7.

11. Assure the Windshield is aligned evenly before tightening hardware.

12. Tighten all hardware to the torque specification below.

13. Remove the protective film from

BOTH

sides of the Windshield Panel. Protective film may be clear on one or both sides which

can be difficult to see.

14.

Re-inspect hardware before and after riding or trailering.

Ill. 1-6

Ill. 1-7

One 1.6mm and one 4.6mm
Thick Spacer per Clamp

Summary of Contents for 1466

Page 3: ...below Keep Screws for later use See Illustration 1 2 6 Attach the Upper Panel assembly to the vehicle Roll Cage Loosely install the hardware into each Clamp The rubber Clamp Spacers Items 5 6 will be installed in later steps See Illustration 1 3 Ill 1 2 Remove OEM Screws Keep for later use Ill 1 3 8 7 8 7 ...

Page 4: ... Upper Panel as shown The Lower Panel should be attached to side facing the front of the vehicle on the Upper Panel See Illustration 1 4 8 Re install the OEM Screws from Step 5 into the lower two holes of the Lower Panel See Illustration 1 5 1 9 8 7 1 Ill 1 4 Ill 1 5 ...