Kollmorgen AKD PDMM series, User Manual

Page: 290 / 513

AKD PDMM User Guide | 28.43 DRV.MEMADDR
General Information
Units mv , Ω
Range N/A
Default
Value
N/A
Data Type String
See Also N/A
Start Version M_01-00-00-000
Description
DRV.LOGICVOLTS reads the logic voltages data of 1.2 V, 2.5 V, 3.3 V, 5 V, 12 V, –12 V, and
3.3 AV.
Example
Below is an example of the output for this command:
ch0 = 1.2V : 1211 mv
ch1 = 2.5V :2488 mv
ch2 = 3.3V :3274 mv
ch3 = 5V :4950 mv
ch4 = 12V :11892 mv
ch5 = -12V :-11912 mv
ch6 = 3.3AV :3300 mv
ch7 = R ohm :100000 ohm
28.43 DRV.MEMADDR
General Information
Type R/W Parameter
Description
Sets the read and write
address.
Units N/A
Range N/A
Default
Value
U8
Data Type N/A
See Also DRV.MEMDATA (pg 291)
Start Version M_01-00-00-000
Description
DRV.MEMADDR sets the address that is used by DRV.MEMDATA. The input can be either
an internal parameter of the drive or any direct address from the DSP address space (SDRAM,
internal RAM, or asynchronous memory). The input value can be either decimal or hexadecimal
with 0x prefix.
Type extension can be one of the following:
U8,S8,U16,S16,U32,S32,U64,S64.
Examples
Setting to an internal parameter:
-->DRV.MEMADDR CCommandHandler.Debug1
Setting to an internal address:
290 Kollmorgen™ | December 2012