16
English
6. Storage
Storing in a place below 40°C and out of the reach of
children.
NOTE
Storing lithium-ion batteries.
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
signi
fi
cantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
However,
signi
fi
cantly reduced battery usage time may
be recovered by repeatedly charging and using the
batteries two to
fi
ve times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries
dead and purchase new batteries.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
Important notice on the batteries for the HiKOKI
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modi
fi
ed (such
as disassembly and replacement of cells or other
internal parts).
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the HiKOKI Authorized Service Center.
1. Power tool
Symptom
Possible cause
Remedy
Tool doesn’t run
No remaining battery power
Charge the battery.
Battery isn’t fully installed.
Push in the battery until a click is heard.
Concrete dust is accumulated on the
terminals of the battery installation
compartment as well as on the battery
sliding grooves.
Clean o
ff
the accumulated concrete dust
with a dry cloth.
Suction power is weak.
Fails to suck in dust.
The tank is full of dust or water.
Dispose of the dust or water.
After that, remove any dust attached to
the
fi
lter.
Filter is clogged.
Conduct air blow dusting or remove the
dust attached to the
fi
lter.
The
fi
lter is not installed.
(Not set in place)
Check to see if the
fi
lter is properly set.
Plastic bag is incorrectly installed.
Properly install the plastic bag.
Dust leaks from the vent.
Cloth
fi
lter is not installed.
Cloth
fi
lter is improperly installed.
Properly install the cloth
fi
lter.
Cloth
fi
lter is damaged.
Replace the damaged cloth
fi
lter.
Tool suddenly stopped
Tool was overburdened
Get rid of the problem causing the
overburden.
The battery and/or the unit is overheated.
Let the battery and/or the unit cool down.
Attachments such as the
connection adapter or joint
-can’t be attached
-fall o
ff
The shape or the dimensions of an
attachment part does not match.
Check the model in use and make sure
to use the designated accessories and
attachments listed in this document or in
our catalogue.
Battery cannot be installed Attempting to install a battery other than
that speci
fi
ed for the tool.
Please install a multi volt type battery.
00Book̲RP3608DA(L)̲Cht.indb 16
00Book̲RP3608DA(L)̲Cht.indb 16
2021/03/18 15:01:59
2021/03/18 15:01:59