KOKEN LM-097B, Instruction Manual

Page: 11 / 16

9
3-6. Add water so that air bubbles can be heard when checking an insertion
Pour 100 ml of water into the tube feeding tank set in the back plate.
Note: Be careful not to add too much water, as this may cause leakage or back flow.
Please make sure that the head of the model is not lower than the body once water has been
poured in. Otherwise, leakage will occur.
3-7. Connect Suction Training Model Type II and tube feeding body
1) Join the tube feeding tank and the esophagus of the Suction Training Model Type II as shown
below.
2) Cover with the body. Place the body on the back plate so that the three hook and loop fasteners
align properly. Push down lightly on the body so that the hook and loop fasteners adhere to each
other.
- 8 -
3-6. Add water so that air bubbles can be heard when checking an insertion.
Pour 100 ml of water into the tube feeding tank set in the back plate.
Note: Be careful not to add too much water, as this may cause leakage or back flow.
3-7. Connect Suction Training Model Type II and tube feeding body.
1) Join the tube feeding tank and the esophagus of the Suction Training Model Type II as shown below.
2) Cover with the body. Place the body on the back plate so that the three hook and loop fasteners align
properly. Push down lightly on the body so that the hook and loop fasteners adhere to each other.
Water 100 ml
Water 100 ml
Hook and loop fasteners
- 8 -
3-6. Add water so that air bubbles can be heard when checking an insertion.
Pour 100 ml of water into the tube feeding tank set in the back plate.
Note: Be careful not to add too much water, as this may cause leakage or back flow.
3-7. Connect Suction Training Model Type II and tube feeding body.
1) Join the tube feeding tank and the esophagus of the Suction Training Model Type II as shown below.
2) Cover with the body. Place the body on the back plate so that the three hook and loop fasteners align
properly. Push down lightly on the body so that the hook and loop fasteners adhere to each other.
Water 100 ml
Water 100 ml
Hook and loop fasteners
- 8 -
3-6. Add water so that air bubbles can be heard when checking an insertion.
Pour 100 ml of water into the tube feeding tank set in the back plate.
Note: Be careful not to add too much water, as this may cause leakage or back flow.
3-7. Connect Suction Training Model Type II and tube feeding body.
1) Join the tube feeding tank and the esophagus of the Suction Training Model Type II as shown below.
2) Cover with the body. Place the body on the back plate so that the three hook and loop fasteners align
properly. Push down lightly on the body so that the hook and loop fasteners adhere to each other.
Water 100 ml
Water 100 ml
Hook and loop fasteners
Hook and loop fasteners