21. Install the Handles
CAUTION: Risk of injury or product damage.
When reassembling the door handle assembly make sure
to re-install the provided spacers in the configuration shown in the attached view. The handles should not
be tightened to the tempered glass hard surfaces without the spacers or it may shatter.
NOTE:
The handle comes pre-assembled and must be disassembled prior to installation on the shower
door.
Unscrew the non-logo handle from the pre-assembled handle assembly.
Remove the spacer from the handle setscrew.
Slide the assembled handle setscrew and handle assembly (logo facing the outside of the shower)
through the hole in the glass shower door.
Re-insert the spacer onto the handle setscrew.
Screw the other (non-logo) handle onto the handle setscrew.
Fully tighten both handles evenly making sure the logo is properly orientated.
22. Install the Threshold Seal
Trim the threshold seal to fit.
Orient the water dam toward the inside of the shower and press the threshold seal onto the bottom
of the glass door panel.
Seal here,
outside only.
Glass Door
Panel
Outside
Handle
Etched
Logo
Spacer
Handle
Setscrew
Spacer
Inside Handle
Bridge Member
Threshold
Seal
Water Dam
Inside of
Shower
Outside
of Shower
Sterling
23
1100676-2-F
