TO REMOVE EXISTING
TOILET
Turn off the water supply. Flush the
toilet, and use a sponge to remove the
remaining water from the tank and
bowl. Disconnect the supply shut-off
valve (if present), and remove the old
tank and bowl.
Remove old gasket from the floor and
closet flange with a putty knife.
Remove old T-bolts and discard them.
If a new toilet is not installed
immediately, temporarily stuff a rag in
the closet flange.
NOTICE:
(
)
T
8mm
T
Install two new 8mm (5/16") diameter
T-bolts into the closet flange.
Do not use white cement or
high lime content cements to install
this toilet. The expansion of cement
due to a rise in temperature may make
the toilet crack or cause damage.
Kohler is not responsible for any
damage caused by installation with the
use of cement.
NOTICE:
TO INSTALL SUPPLY
SHUT-OFF VALVE
Install toilet supply shut-off valve so it
is 229mm above floorline and 105mm
to the left of the centerline of the closet
flange. Centerline of supply shut-off
outlet should extend 102mm from
finished wall. Install the supply shut-off
valve with outlet vertcial.
229mm
105mm
102mm
TO INSTALL NEW TOILET
Place new toilet upside down on
padding. Firmly place gasket on toilet
outlet.
Wax ring type toilet gasket
should not be installed at temperatures
less than 21
.
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
If you temporarily plugged the closet
flange with a rag, remove the rag at
this time and ensure that the drain pipe
is clear and free of debris.
NOTE 1:
NOTE 2:
1
21
2
Closet Flange
Fig.#2
2
Fig.#3
3
T-Bolts
T
Closet Flange
Fig.#4
4
Fig.#5
5
Toilet Outlet
Toilet Gasket
305
229
105
Supply Shut-Off Valve
Closet Flange
Centerline
-3-
INSTALLATION
1182021-T01-C
