12
1058907-W2-J
Flow Shut Off Setting
1.
Fully open the inlet isolation valves.
2.
Remove the lever using the 2.5 mm A/F hexagonal wrench, and remove the
stop ring.
3.
Refit the lever to the spindle (position not important) and open the tap.
4.
Turn the lever to the off position so the flow
just stops,
then rotate a further
10 - 20 degrees, to make sure of a tight shut off.
5.
Remove the lever and refit the stop ring with the arrow aligned with the tap
spout (refer to illustration).
6.
Fit the lever to the spindle in the
OFF
position (parallel to the wall) and make
sure that the lever engages with the stop, i.e. cannot be turned clockwise (refer
to illustration).
Lever in Stop Position
Stop Ring Alignment
Stop Ring
