Kohler Co.
3
1015627-X2-A
Install the water supplies and drain piping according to the
roughing-in information. Install the supply stops so the handles
will not touch the pedestal when fully open.
Install sufficient backing behind the finished wall to provide a secure
material for the anchoring devices.
Install the hanger according to the roughing-in information.
Carefully lift the lavatory into place on the hanger, and level. You may
need to raise or lower the hanger so the lavatory contacts the wall
evenly.
NOTE:
The lavatory
must
be supported by the hanger.
Locate the two lavatory anchoring holes, and mark the hole locations
on the finished wall.
Carefully position the shroud under the lavatory, and mark the
finished wall at the upper anchoring hole locations.
Carefully remove the shroud and lavatory from the area.
1. Preparation
