15
TT-855 12/93
Operation
Charger Voltage Adjustment
The battery charger’s output settings are factory set and
normally require no customer adjustment. If adjustment
is required, contact an authorized distributor for service
or service literature. The factory settings are listed
below.
Factory Output Settings
Charger
Voltage
Float
Voltage
Current
Limit
12 V
13.2 V
2 A
24 V
26.4 V
2 A
Charger and Battery Maintenance
WARNING
Hazardous voltage.
Do not operate generator set without all guards
and electrical enclosures in place.
Moving rotor.
Can cause severe injury or death.
Hazardous voltage can cause severe injury or
death. Electrical shock may occur if battery charger is
not properly grounded. Connect battery charger
enclosure to ground of a permanent wiring system. As
an alternative, run an equipment-grounding conductor
with circuit conductors and connect to
equipment-grounding terminal or lead on battery
charger. Battery charger installation should be
performed as prescribed in equipment manual and must
comply with all local codes and ordinances.
(Applies to Optional Battery Charger.)
Hazardous voltage can cause severe injury or
death. Improper reconnection may damage charger
and battery(ies), and create an electrical shock hazard.
Installation must be done by a qualified electrician.
(Applies to Optional Battery Charger.)
Hazardous voltage can cause severe injury or
death. Short circuits can cause bodily injury and/or
equipment damage. Do not contact electrical
connections with tools or jewelry while adjustments are
made. Remove wristwatch, rings, and jewelry that can
cause short circuits.
WARNING
Sulfuric acid in batteries.
Can cause severe injury or death.
Use protective goggles and clothes. Can cause
permanent damage to eyes, burn skin, and eat holes
in clothing.
Sulfuric acid in batteries can cause severe injury or
death. Sulfuric acid in battery can cause permanent
damage to eyes, burn skin, and eat holes in clothing.
Always wear splash-proof safety goggles when working
around the battery. If battery electrolyte is splashed in
the eyes or on skin, immediately flush the affected area
for 15 minutes with large quantities of clean water. In the
case of eye contact, seek immediate medical aid. Never
add acid to a battery once the battery has been placed in
service. Doing so may result in hazardous spattering of
electrolyte.
NOTE
Warranty repairs must be made through an authorized
dealer.
1. Check battery terminals and charger connectors
for clean contact surfaces. Clean battery
terminals and charger connectors as necessary
with a mild baking soda/water solution. If battery
charger does not work, see Troubleshooting
section.
2. Check battery fluid level regularly; maintain
battery fluid at proper level.