Kohler LOMBARDINI MARINE KDI 1903M-MP, Owner'S Manual

Page: 29 / 48

6
29
_04
A
A
C
D
E
6.1
6.2
6.3
MIN
MAX
B
B
INFORMATION ABOUT REPLACEMENTS
EN
Danger
Disconnect the negative wire (-) from the battery to avoid accidental engine starting.
Important
Before proceeding with operation, read Par. 3.2.2
6.1 Engine oil replacement
Important
• Place engine on horizontal surface to ensure accurate
measurement of oil level.
NOTE: Perform this operation with warm engine,
to get a better fluidity of the oil and get
a full discharge of oil and impurities
contained in it.
1. Loosen the oil filler cap A.
2. Remove the oil dipstick B (Fig. 6.3).
3.
Remove oil drain plug D from pump E.
4. Start pump E and drain the oil in the engine.
5. Drain oil in an appropriate container.
(For the exhausted oil disposal, refer to
Par. 6.9 DISPOSAL and SCRAPPING ).
6. Tighten the drain oil plug D (tightening torque at 10 Nm).
7.
Perform the operation described in Par. 6.2 .
8. Add the type oil recommended ( Tab. 2.1 and Tab. 2.2 ).
9. If the plug A is not accessible, use the oil filler cap C.
10. Fit and remove the oil dipstick B to check the level. Pour
in fluid until reaching the MAX level mark.
11. Upon completion, reinstall the oil dipstick B completely.
12. Tighten the cap A or C.
Important
• Do not exceed the MAX level on the dipstick.
• Do not use the engine with the oil level below the MIN.
ED0053030870