4. Install the Faceplate and Lever Handle
CAUTION: Risk of product damage to the K-306–KS valve
assembly.
When using this valve in a fiberglass or acrylic
installation, use the Thin Wall Installation Kit (88526).
Remove and discard the plaster guard and/or dome, if installed.
Fit the faceplate and centering washer over the valve, and secure
with two screws.
Rotate the valve stem fully counterclockwise.
Lever Handle
Fit a sleeve and bonnet over each stem adapter.
Thread a bonnet to each valve body until they are tight against
the escutcheon.
Install a center cap to each bonnet.
Fit a long sleeve to each handle arm, and secure it with the end
cap.
Insert a handle arm through each center cap and bonnet.
Install a short sleeve and washer onto each handle arm and
secure them with the end cap.
Valve Stem
Faceplate
Screws
Centering Washer
Discard plaster
guard with dome.
Valve Stem
Short Sleeve
Handle Arm
Long Sleeve
O-Ring
Bonnet
Sleeve
Screw
Washer
End Cap
Center Cap
Kohler Co.
7
114498-2-E
