4. Install the Pivot Side Wall Jamb
Position the
pivot side
wall jamb on the wall 3/8
″
(10 mm) from the front ledge of the shower base.
Plumb the wall jamb using a level.
Temporarily secure the wall jamb with masking tape.
Mark the location of the four wall jamb slots on the wall.
Remove the masking tape, then move the wall jamb to a safe area.
IMPORTANT!
The supplied 6 mm drill bit is not suitable for drilling through tile. For tile installations,
use a 6 mm tile bit.
Slowly drill the marked hole location, using the provided 6 mm drill bit for non-tiled walls.
Insert an anchor into each hole. Make sure the anchors are flush with the finished wall.
Secure the wall jamb to the wall using the four #8 x 1-1/2
″
screws.
3/8"
(10 mm)
6 mm
Kohler Co.
7
1280798-2-B
Summary of Contents for K-706139
Page 49: ...1280798 2 B ...
Page 50: ...1280798 2 B ...
Page 51: ...1280798 2 B ...
Page 52: ...USA Canada 1 800 4KOHLER México 001 800 456 4537 kohler com 2016 Kohler Co 1280798 2 B ...
