Cover
便蓋
Seat
座圈
Flush-eco
小沖
Flush-full
大沖
Seat temp
圈溫
UV
Stop
停止
Front
女性沖洗
Rear
臀部沖洗
Dryer
暖風
Clean
紫外線除菌
Water temp
水溫
Massage
脈沖
/
移動
Spiral
旋轉沖洗
Wand
噴管移動
Pressure
水壓
Red Lamp Flicker
Usage and Replacement of Battery for Remote Controller
Others
□
Do not put the remote control at a place where it may be sprayed by liquid, or immersed in liquid.
□
Do not place it near hand dryer, hair dryer and small size home appliances, to avoid disturbance of
normal usage of the remote control.
□
Do not apply external force to the key zone of remote controller frequently or fiercely.
□
After usage of remote control, put it back into the
remote holder
mounted on wall.
□
Prevent dropping the remote control during usage.
□
Anti-loss function: lock remote on docking station by screws. Specific method refers to installation instruction.
Keep pressing the key until a short
beep
is heard, and release the key only after the night lamp flickers for
three times. Then change the setting of B/C/E/F/O by the following requirements.
B
-
Open/close the cover…Sensing distance setting
2.
Night light slow flickers once to turn off auto UV function (long beep)
.
Battery holder -
of remote controller uses 4 #5 alkaline batteries.
When battery is low,
the battery holder lamp will flicker in red indicating
the batteries need to be replaced, indicate the replacement of battery.
Caution:
1.
The positive and negative polarities of battery must be consistent with
the mark of remote controller.
2.
New and old batteries shall not be mixed.
3.
Please use alkaline battery.
Press and hold the key to set up the sensing distance for auto cover-turning:
1.
Night light quick flickers once means short distance (short beep)
.
2.
Night light quick flickers twice means mid distance (short beep) .
3.
Night light quick flickers three times means long distance (short beep).
4.
Night light slow flickers once means turn off auto lid-turning function (long beep).
C - Seat On/Off…Deodorization function setting
●
●
●
●
Press and hold this key to turn on/off the deodorization function.
1.
.
2.
.
●
Press and hold this key to turn off the function of automatic flushing. Press and hold it again to restore
1.
Night light quick flickers once to turn on auto flush function (short beep).
2.
Night light slow flickers once to turn off auto flush function (long beep).
●
Press and hold the key of Seat Temp to activate the function of energy saving. Press and hold it again to
.
.
●
●
Under non-seating status, press and hold this key to activate the function of manual cleaning. The nozzle can be
O - UV sterilization (UV light)…Setting of UV automatic sterilization
Night light quick flickers once to turn on auto UV function (short beep).
1.
2.
E - Flush-full…Automatic flushing setting
flushing.
F - Seat temp…Energy saving setting
function.
Press and hold to set up the on/off status of automatic UV sterilization.
1.
When the setting of B/C/E/F/O is not modified for a certain period, repeat the process that is to keep pressing the
key until a short pip is heard and release the key only after the night lamp flickers for three times before
the next change of setting.
M - Effuser movement…Effuser cleaning settings
Kohler Co.
9
1413476-TW01-A
