7. Install the Finished Wall
Finished Wall
9-1/4"
(235 mm)
Front View
10-1/2" (267 mm)
8" (203 mm)
Flush Shield
CAUTION: Risk of product damage. Do not puncture the water tank with fasteners. A template to assist in
securing the finished wall is located on the inside of the box lid. Hang this template on the flush shield to identify
the tank location.
IMPORTANT! Gypsum board may compromise the load strength of the toilet installation. Kohler Co. recommends the
use of cement board or tile backer board for the wallboard backing.
NOTE: The wall thickness should not exceed 2-3/4" (70 mm).
Install the finished wall.
Use a sharp utility knife to carefully trim the flush shield even with the finished wall.
NOTICE: Retrieve and retain the actuator frame locking pins and bowl nut, washer, and cap set from inside the flush
shield.
Discard the trimmed off portion of the shield.
Kohler Co.
11
1430967-2-
B
Summary of Contents for K-4177
Page 42: ...1430967 2 B 42 Kohler Co...
Page 43: ...Kohler Co 43 1430967 2 B...
