3.
Tighten the slurry mold and valve box with short
screws and then apply slurry into the crevice around
the valve box. Lay the tiles.
4.
When the slurry turns solid, remove the short
screws, pull out slurry mold, mount the bracket assy,
and secure with long screws.
USER’S GUIDE
NOTICE:
The first 10 minutes with power is the standby time for adjusting sensing distance. Persons or subjects
should avoid standing before the sensor. The sensor will not flush during this time.
Set Working Status:
The product comes our factory with:
1. The working status is set as dual-flush. If you want to cancel the first flushing function, place manual flush
stick adjacent to right side of sensing window for more than 1 second during the 10-minute standby period
(Human presence in sensing range would cause the indicator to flash fast). The sensor would generate a
flushing cycle to indicate the setup of the sensor has been adjusted to after-use flushing. If the action is not
completed during this 10 minute, or you need to restore the working status to dual-flush, plug off the power
cord and reconnect the power supply until the indicator stops flashing and repeat the above procedures.
2. The diction time is set as 2s to avoid improper function in narrow toilets, the detection time is automatically
set from 2s to 5s.
Working Status:
Before powering the system on, clear the unwanted objects in front of the sensor window
lest shortening the sensing distance.
Sensing Distance:
During the first 10 minutes, when powered on, the system is in the phase of automatic
regulation, and no operation is required.
Deodorizing Flushing:
The urinal will take a flush automatically when it’s used 3 or 4 times in 2 minutes.
5.
While using AC power for 8787X-B03, connect solenoid valve with control box assy, and then connect AC power
supply to power unit.
Install the cover as shown in the figure:
a. Buckle the sensor cover into the wall slightly above bracket assy.
b. Press the sensor cover down along the wall and fit tightly into the bracket assy.
c. Push upward with hex wrench and rotate clockwise to lock the sensor cover.
Short Screw M4x10
Long Screw M4x50
Slurry Mold
Slurry Mold
Tiles
<40
Valve Box
a
b
c
Indicator
Hex Wrench
1106445-X2-A
6
Kohler Co.
