4. Connect the Components
CAUTION: Risk of electric shock or product damage.
Make sure the power cord for the media
module is unplugged or the power supply is turned off before removing the access covers.
Remove the low voltage access cover on the media module.
Remove the grommets in the locations where the interface cable will be installed. Refer to the
″
Connection Key.
″
Gently press each connection until it snaps together.
Slide the cable grommet into the slot with the male end up. Verify the grommet is properly seated.
Reinstall the access cover. Do not overtighten.
Plug the media module power cord into the outlet, or for hard-wire options, turn on the power.
Verify that the indicator light turns on and pulses.
Test each component to ensure proper functionality. Refer to the Installation and Homeowner
Guides packed with each of the individual components for additional information.
5. Complete the Installation
If not already installed, install any additional components at this time according to the installation
instructions packed with the products. For connecting to the media module, refer to the
″
Connect
the Components
″
section in the Media Module Installation Guide.
Reinstall the media module access covers. Do not overtighten.
Make sure power cord is unplugged
before opening access covers.
Grommet
Slide grommet into slot with
male end up.
High Voltage
Access Cover
Low Voltage
Access Cover
Install grommets
flush with media box.
Male End
Indicator Light
Kohler Co.
11
1093343-2-B