SYMPTOMS
A. Replace motor/pump.
B. Replace control.
PROBABLE CAUSES
10.Pump operates but
variable speed
feature does not
work.
A. Motor/pump does not work.
B. Control does not work.
A. Allow bath water to cool.
B. Turn heater on.
C. Check wiring for proper connections.
D. Replace heater.
E. Replace control.
11.Bath water cools
while pump is
operating.
A.
o
o
Water temperature above 104 F (40 C).
B. Heater is turned off on user keypad.
C. Wiring from heater to control is loose,
disconnected, or damaged.
D. Heater does not work.
E. Control does not work.
A. Cut pump banding straps with tin snips.
B. Remove jet, replace and lubricate O-ring,
then reinstall jet.
12.Noisy operation.
A. Pump banding straps have not been cut.
B. Dry or dislodged jet O-ring (squeal).
A. Replace batteries.
B. Replace wiring harness.
C. See homeowners guide or service manual.
D. Replace remote control.
E. Replace control.
A. Check for loose or damaged wires.
Repair or replace as needed.
13.Remote control does
not work or operates
both pumps.
14.Lights near whirlpool
floor do not
illuminate.
A. Batteries improperly installed or dead.
B. Antenna on wiring harness is damaged.
C. Remote control not programmed correctly.
D. Remote control does not work.
E. Control does not work.
A. Wiring damage.
Troubleshooting continued
A.
/
B.
10.
A.
/
B.
A.
B.
C.
D.
E.
11.
A.
40
B.
C.
D.
E.
A.
B.
O
12.
A.
B.
O
(
)
A.
B.
C.
D.
E.
A.
13.
14.
A.
B.
C.
D.
E.
A.
17
RECOMMENDED ACTION
1141609-T01-A
