Fill the Whirlpool
NOTE:
NOTE:
Please read these steps carefully before you
operate your whirlpool.
Turn the jet trim rings fully counterclockwise.
Position the jet nozzles so they face down toward
the basin.
Fill the whirlpool with water until the water level is
above the highest backjet.
The water temperature in the whirlpool should
not exceed 104 F (40 C). The heater will automatically
turn off as the water temperature approaches 104 F
(40 C) and will remain off until the water cools.
o
o
o
o
·
·
40
40
·
·
12
CONFIRM PROPER OPERATION
CONFIRM PROPER OPERATION
Your whirlpool is equipped with two keypads, each
controlled by its own operating system. Follow the
steps below to confirm the keypads are operating
correctly.
A built-in heater automatically helps to maintain
the water temperature when the whirlpool is running, as
long as the water temperature does not exceed 104 F
(40 C). The heater will disengage at higher
temperatures.
Please refer to your Homeowners Guide
for detailed instructions on the user keypad and remote
control.
The keypad controls the chromatherapy feature.
Press the Power On/Off button on the keypad to
turn the whirlpool on. The whirlpool will start at
medium flow and three small lights near the
whirlpool floor will illuminate as long as the keypad
remains lit.
Increase or decrease the water flow by pressing
either the up or down arrow buttons on the keypad.
An indicator bar in the center of the keypad shows
the water flow volume.
Adjust each Flexjet for optimum air/water mixture.
Turn the Flexjet trim clockwise to reduce the air flow
and counterclockwise to increase the airflow.
NOTE:
IMPORTANT!
NOTE:
o
o
·
·
·
Water-Level Sensors - To use all functions (including
backjets), fill to a level above both water-level sensors.
(
)
Flexjet - Turn the jet trim ring fully
counterclockwise and position the
jet nozzle downward.
Suction Cover
2
/
3
40
40
/
·
·
·
OPERATING SEQUENCE
OPERATING SEQUENCE
1141609-T01-A