4. Install the Wood Surround Outriggers
Press the short cams into the large holes in the four outriggers. Make sure the cam heads are flush
with or slightly below the surface of the wood.
Use a phillips screwdriver or the hex wrench provided to turn the cams so the arrows face the ends
of the outriggers.
Wet the stud threads, and use a phillips screwdriver to thread the four studs into the small holes in
the wooden legs.
Securely tighten the screws. Do not overtighten.
Turn the outrigger levelers fully clockwise.
Read the removable labels on the outriggers to determine the correct installation location of the
outriggers.
Turn the outriggers sideways, and press them onto the studs. Pivot the outriggers into the vertical
position. You may need to raise the bath slightly to get the outriggers into position.
Use a phillips screwdriver or the hex wrench provided to turn the cams 1/2 turn clockwise to
secure the outriggers to the leg assemblies.
Turn the outrigger levelers until they make contact with the finished floor.
Outrigger
Bath
Stud
Drain Hole
Bath
Outrigger
Stud
Cam
Outrigger
Back End-
Left
Back End-
Right
Front End-
Left
Front End-
Right
Direction of
Arrow
Outrigger
Leveler
Short
Cam
Wooden Bath Support Foot
(Installed at Factory)
Wooden Bath
Support Foot
(Installed
at Factory)
Kohler Co.
5
1007292-2-B
Summary of Contents for Iron Works Tellieur K-727
Page 23: ...1007292 2 B ...
