Replacing the Batteries
NOTE:
The red light on the docking station will blink when the batteries are low. The
″
stop
″
icon on the
remote control will blink when it has a low charge and should be returned to the docking station.
If the remote control is secured to the docking station, remove it and set aside.
Remove the docking station from the wall by carefully lifting up and out.
Open the back compartment on the docking station by pushing both tabs outward at the same time.
Install four AA batteries, oriented as shown in the battery compartment.
Reinstall the cover.
Reinstall the docking station on the wall.
Troubleshooting
NOTE:
For service parts information, visit the product page at kohler.com/serviceparts.
Small Children
The automatic flush and cleansing features are activated by a sensor located under the seat. Small
children may not be tall enough to be detected by the sensor.
General
Symptoms
Probable Causes
Recommended Action
1.
The toilet beeps while
occupied.
A.
The seat has been occupied for
an extended period of time.
A.
No action required. This is simply
an indicator beep.
2.
The toilet has no power.
A.
The power cord is not
connected.
A.
Connect the power cord.
B.
The GFCI or RCD is tripped.
B.
Reset the GFCI or RCD.
C.
The toilet is in standby mode.
C.
Press any icon on the side control
panel to reactivate the toilet.
D.
The internal switch is turned off.
D.
Remove the right side panel and
turn the internal switch on.
3.
The toilet has power but
does not flush.
A.
No water being supplied to the
toilet.
A.
Fully open the water supply stop.
Back of Docking Station
Kohler Co.
13
1295780-5-A
PROOF
