Kohler GLS-1, Installation Instructions Manual

Page: 11 / 32

TT-1686 3/16 11
20. If current sensing is required (i.e. for current [amps]
monitoring and display), obtain the appropriately
rated current sensing kit and install according to
Figure 19.
21. Connect the current transformers as shown in
Figure 20. See Figure 3 or the Parts List for current
sensing kit numbers.
1. Connect harness GM40562 (10 ft. harness). See Figure 20 for electrical connections.
2. Current transformers. See Parts List for part numbers.
2
NOTES:
HI SIDE OF CT’S MUST ALWAYS FACE TOWARD THE CONTACTOR.
Route CT harness neatly to controller with controller/contactor harness. Use cable ties as necessary.
See wiring diagram GM47803 (Figure 20).
Decision-Maker
r
1500 Controller
GM89029
FROM BOTTOM SIDE
OF TERMINAL BLOCK
TO PCB CONNECTOR
X-6126-27
GM21583 (2)
GM47797 (INSULATION)
(SHOWN PHANTOMED)
ASSEMBLE UNDER SCREWS
HOLDING BRASS STRIP TO
TERMINAL BLOCK.
REMOVE BRACKETs FROM CT’S AND DISCARD BRACKETS.
ASSEMBLE CT’S ON LOAD BUS (A, B & C)
(LUGS MUST BE REMOVED FIRST AND
REASSEMBLED AFTER MOUNTING CT’S)
TIE WRAP TO VERTICAL
BUS SUPPORTS AND EACH OTHER.
1
Figure 19 Current Sensing Kit Installation