INSTALLATION INSTRUCTIONS
-2-
30mA
·
·
·
·
·
·
WARNING: When using electrical products,
basic precautions should always be followed,
including the following:
WARNING: Risk of electric shock.
Grounding is required.
WARNING: Risk of injury or property damage.
WARNING: Risk of electric shock.
WARNING: Risk of electric shock.
NOTICE: Follow all local plumbing and electrical
codes.
Connect
only to a circuit protected by a Residual Current
Device (RCD) with residual current less than
30mA.
Building materials and wiring should be routed away
from the whirlpool pump, blower motor, and other
heatproducing components of the unit.
Install to permit access for servicing.
A pressure wire connector marked "Earth/Ground" is
provided within the wiring compartment. To reduce
the risk of electric shock, connect this connector to
the grounding terminal of your electric service or
supply panel with copper wire equivalent in size to
the circuit conductor supplying this equipment.
Pressure wire connectors are provided on the
exterior of the junction box or control within this unit
to permit connection of a bonding conductor
between this unit and all other exposed metal in the
vicinity, as needed to comply with local
requirements.
An equipment grounding terminal is provided in the
field wiring compartment. To reduce the risk of
electric shock, this terminal must be connected to
the grounding means provided in the electric supply
panel with a conductor equivalent in size to the
circuit conductors supplying this equipment.
The unit should be installed
by a qualified service representative, and grounded.
Please read all instructions thoroughly before
beginning installation.
A qualified
electrician should make all electrical
connections.
Disconnect
power before servicing.
·
·
·
·
·
·
1397340-T01-A
