3. Setup of Flushing Volume
The default flushing volume of this product is followed (4L, 6L).
SW1 has set as ON, SW2 and SW3 as OFF. Users can set
the flushing volume as needed per the table below by turning
on the right switch of the setup switch assembly. However,
these operations should be completed within five minutes
after power on. Power on and ten seconds after the
connection of the setup switch assembly and control box, the
setup of the flushing volume is complete. After the setup,
keep safe the setup switch assembly.
3
.
(4L
6L)
SW1
ON
SW2
SW3
OFF
5
10
,
(
)
1 2 3 4
ON
Sw4 is empty
Sw4
*Setup Switch Unit
*
ON
(dual flushing mode)
For liquid
wastes only
For solid
wastes
Flush
volume
Flush
volume
OFF
(single flushing mode)
Water per flush (L)
SW3 SW2
SW1
OFF
OFF
ON
ON
OFF
ON
OFF
ON
4
6
6
8
6
6
8
11
4
6
8
11
SW3 SW2
SW1
OFF
OFF
ON
ON
OFF
ON
OFF
ON
4
6
6
8
6
6
8
11
4
6
8
11
ON(
)
(
)
(
)
OFF(
)
(
)
-13-
Notice:
a. After finishing these steps, the toilet sensor
is ready for use.
b. The sensor cover installing must be
finished within five minutes after power on.
If this is not accomplished within 5 minutes,
shut off the power. When the indicator
stops flashing, power on again and repeat
the above steps.
c. Don't mistake the polarity of the batteries
and don't mix the new and used batteries
together.
d. Tighten the screws of the battery box to
avoid the batteries from wetting.
a.
b.
5
5
c.
d.
1046837-T01-D
