13
•
Never steam one spot for too long. This can cause floor surface damage.
•
Do not put hands or feet under the steam cleaner. Unit gets very hot.
•
During use, a pulsing noise may be heard indicating that the mop is producing
steam. This noise is normal.
•
There may be some minor "spitting” of water mixed with the steam. This is also
normal.
•
The force and heat of the steam may adversely affect certain materials. Always
check the suitability of using the steam cleaner on a surface by carrying out a
preliminary test on a hidden area.
How to Use the Hand-held Steamer
Make sure that the steam cleaner is not plugged into a power outlet.
1. Fill the water tank with water. Please refer to the “How to Use the Steam Mop Sweeper”
section in this manual. Attach either the round nylon brush or the round copper brush as
explained in the “How to assemble Hand-Held Steamer” section in this manual.
2. Select one of the following steam regulator positions:
1-Low, 2-Medium, 3-High or 4-Hot spray. You can change the steam regulator position and
the steam output while operating the steam cleaner.
3. Once the unit has been fully assembled and filled with water, plug in the power cord to a
grounded electrical outlet. Steam switch (O/I) is in the OFF (O) position, turns the steam
switch (O/I) to the ON (I) position. Approximately after 8 seconds, the mop will start
emitting steam. Adjust the steam according to your requirement. To stop emitting steam,
you need to turn off the steam switch. Make sure to turn the unit totally OFF after each
usage and disconnect from the electrical outlet so the unit is in the totally OFF status
when used next time.
Summary of Contents for KASWPSTM11A
Page 4: ...4 Overview ...
