Thermostat Reset
If during operation, the heating element isn’t working, the manual thermostat may need to
be reset. To perform a thermostat reset follow the below procedure:
•
Turn the program selector dial to the “Air Dry” position and press the start button.
•
Wait approximately 20 minutes and then press the thermostat reset button.
After Running a Program
All drying programs will end with a 5 or 10-minute cooling phase. If the laundry is not
removed at the end of the cycle, the dryer will enter an anti-creasing phase (30 minutes
maximum). If you do not remove the laundry, the dryer will stop automatically at the end of
the anti-creasing phase. The display shows “End” and the buzzer sounds for 15 seconds, if it
has been enabled. Turn the program selector dial to the “off” position.
Important!
If the drying program has to be stopped before it reaches the end, we recommend that you
turn the program selector dial to position “Air Dry” and wait until the end of this cooling
phase before removing the laundry. This will avoid a build-up of heat inside the appliance. To
do this first turn the dial to “off’ and then to “Air Dry” and press the “Start” button.
Thermostat reset button
Note:
Ensure the lint filter is cleaned after every cycle and whenever prompted by the dryer.
Summary of Contents for KAGVNTDRY7A
Page 1: ...7KG VENTED DRYER KAGVNTDRY7A ...
Page 2: ......