MJ400252C1
- 12 -
6-8 Parameter setting
When an instantaneous flow rate/integrated flow rate is being indicated, pressing and holding
the shift key [
＜
] and [ENT] key for approx. 3 seconds sets the parameter setting mode. Each
time the up key [
∧
] or down key[
∨
] is pressed, the mode No. changes. To change the set value,
change the digits with the shift key [
＜
] and change the figures with the up key [
∧
] or down key
[
∨
].
After setting a parameter, pressing the [ENT] key registers the set value and returns the mode
to the mode No. indication mode. Pressing the shift key [
＜
] while the mode No. is being
indicated returns the indication to either the instantaneous flow rate or integrated flow rate.
①
Default values
Mode No.
Default Value
Set Item
ABCD
A
B
C
D
P
－
01
1.
0
Damping constant setting
P
－
02
3
Unit of flow rate setting
0
5.
0
0
Full scale flow rate setting
P
－
03
Factory-set value
K factor value setting
P
－
04
0
0
Low flow rate cut setting
P
－
05
0
1.
0
Liquid viscosity setting
P
－
06
0.
0
J value (temperature coefficient) setting
P
－
07
1.
0
0
Liquid density setting
P
－
08
0
1.
0
0
Liquid kinematic viscosity coefficient setting
P
－
09
0
5.
0
0
Upper limit flow rate alarm setting
P
－
10
0.
0
0
Lower limit flow rate alarm setting
P
－
11
3
Unit of integrated flow rate setting
P
－
12
0
5
Integrated flow rate (lowest region cut) setting
P
－
13
1
Alarm output 1 type assignment setting
P
－
14
2
Alarm output 2 type assignment setting
P
－
15
0
0.
0
0
Integrated flow rate alarm setting
P
－
16
0
0
1
Equipment address setting
