Koden MDC-900 Series, Operation Manual

Page: 65 / 83

MDC-900 Series Chapter 5 Equipment
0093142132-05 5-13
1. Make a square hole of 220x220 (depth x width) on the installation place. (See the illustration
below.)
Unit: mm (inch)
4-4mm (4-5/32)
Hole for screw
Threading
hole
R25 (63/
64)
220
(8 21/32)
(8 13/16)
224
2.
Turn counterclockwise the knob bolt fixing the display unit to the installation bracket to loosen and
lift the display unit upward. The bracket and the knob are no longer used.
3. Confirm that the display unit fits the square hole by mating them. If not fit, correct the square hole.
4. Insert a coin in the gap at the lower part of the display unit and remove the front frame. (Refer to
the illustration below.)
5.
Connect all of the connectors for power, antenna and others to the main unit.
6. Insert the indictor in the place (square hole) and fix it with four pieces of 4mm tapping screw (or
M4 pan-head screws). (Prepare 4mm screws suited for thickness of the installation part.)
7. Install the front frame removed in step 4.
5.4 Adjustment after Installation
Before setup, confirm the following points to operate properly the equipment
1. The ship’s power, to which the radar system is connected, should be the specified voltage.
2. No person should be present around the antenna and mast. The display unit should bear the
placecard, describing the caution [Radar being adjusted, do not touch the operating block.]
Insert a coin and remove the front frame
by depressing to lift up the front frame.