Koden CVR-010, Operation Manual, Page: 67 / 114

CVR–010
Advanced Settings
57
8.10.6. Setting Date and Time
・
After deciding which time reference to display, UTC or LST (local standard time), via the
preceding procedure (paragraph 8.10.5), set the date and time via the steps outlined
below.
< C A U T I O N >
If you plan to plug in a GPS sensor, be sure to enter the correct UTC time offset
before setting the date and time, or an incorrect date/time readout will result when a
GPS–derived data sentence ($GPRMC or $GPZDA) comes in.
(1) Select option “ 5:CLOCK PRESET ” by pressing numeric key

, opening the CLOCK
PRESET submenu, ready for entering the current date and time.
- The date must be entered in Day/Month /Year (DD/MM/YY) format.
- The time must be entered in 24–hour (hh:mm:ss) format.
Figure 8-26 Setting Date and Time
- The highlighted and blinking character
(character highlight) can be edited.
(2) Enter the current date using

/

and

/

.
- Press

/

to shift the highlight to the
character to be edited.
- Press

/

to edit the highlighted
character.
(3) Press

to complete the entry.
(4) Press

to exit the menu mode.
Figure 8-27 Entering Current Date and Time – Example
・
The built–in clock is battery–backed, eliminating the need to set the date and time again
after the equipment is switched off and on again.
MAIN MENU
9:INSTALLATION SETTINGS
1:ECHO COLORS
2:DEPTH UNIT
3:DYNAMIC RANGE
4:UTC/LST(offset)
5:CLOCK PRESET
6:TRANSDUCER SETTINGS
7:DATA OUTPUT PORT
8:BOTTOM MISSING ALM
9:DEPTH READOUT RESPONSE
0:KEY BEEP SETTING
Character highlight
5:CLOCK PRESET
DD/MM/YY hh:mm:ss
1 3 /0 6 /1 9 0 0 : 00 : 00
5:CLOCK PRESET
DD/MM / YY hh:mm:ss
1 3 /0 6 /1 9 0 0 : 00 : 00
Character highlight
( Entering Date)
Character highlight
5:CLOCK PRESET
DD/ MM/ YY hh:mm:ss
1 3 /0 6 /1 9 14:30:0 0
( Entering Time)