32/KODAK M-SERIES PROJECTORS
DOG ON SHUTTER-DRIVE SHAFT
OUTER LUG ON SHUTTER
DOG ON SHUTTER-DRIVE SHAFT
INNER LUG ON SHUTTER
FIG. D113 Shutter-drive shaft and shutter--
position at reverse.
FIG. D114 Shutter-drive shaft and shutter--
position at forward.
D112, and in the photo of the front view, Fig. D113). In
most situations, the only reason for removing the cover plate
is to replace the rewind driver.
In the drawing, Fig. D112, you can see how the rewind lever
fits in the slot at the back of the rewind driver. Tilt the
rewind driver slightly, Fig. D114, to clear the rewind lever.
Then lift out the rewind driver.
On reassembly, clip the slot at the back of the rewind driver
over the rewind lever, Fig. D112. Align the two lugs on the
rewind driver on a horizontal line with the two tabs at the
front of the pulley, Fig. D111 (in this case, our replacement
rewind driver is white in color—the rewind driver we're
replacing is black).
Replace the cover plate. Then match the position of the
supply spindle with the tabs on the rewind pulley and on the
rewind driver—position the slots at the back of the spindle,
Fig. D109, on the same horizontal line as the tabs on the
rewind driver. Push on the supply spindle until it clicks into
place. Follow the same procedure to replace the take-up
spindle. But here you need only align one slot—the slot at
the back of the take-up spindle with the tabs on the take-up
pulley.
TESTS AND ADJUSTMENTS
1. Still-mask changeover rod.
Check the position of the
still-frame heat-absorbing filter as you turn the speed-control
knob. Make sure that...
-at the slowest running speed, the still-frame heat-
absorbing filter completely clears the film aperture.
-at still, the still-frame heat-absorbing filter moves into
the film aperture.
If the operation of the still-frame lever isn't correct, reposi-
tion the snap ring at the end of the still-mask changeover rod,
Fig. D112.
-
if the still-frame heat-absorbing filter doesn't move
Þ
Þ
Þ
Þ
Þ
Þ Þ Þ Þ Þ
1
2
REWIND
PULLEY
REWIND-
DRIVER
LUGS
FIG. D111 The replacement rewind driver
aligned with the tabs on the rewind pulley.
FIG. D112 End of the still-mask changeover
rod.
Compliments of:
www.KodakParts.com
Summary of Contents for Instamatic M Series
