11
CARE AND CLEANING:
• To prolong the original appearance, clean with clear water and a soft, damp
cloth only.
• Do not use paints, solvents, or other chemicals on this light fixture. They could
cause a premature deterioration of the finish. This is not a defect in the finish
and will not be covered by the warranty.
• Do not spray with a hose or power washer.
• When power is on, the PIR sensor enters a “warm-up” period for about 40
seconds, then automatically switches into AUTO MODE.
• During AUTO MODE, by switching the main switch OFF for about 1 second then
ON, the PIR sensor will automatically change into MANUAL MODE from AUTO
MODE. In MANUAL MODE, the lights will remain ON, and will NOT be controlled
by time duration or ambient light (LUX) levels. The MANUAL MODE will
change to AUTO MODE in 6 hours automatically.
• During MANUAL MODE, by switching the main switch OFF over 30 seconds then
back ON again, the PIR sensor will reset to the “warm-up” period.
To enable the manual override function, rotate the motion sensor so the controls
face towards the ground.
The Blue LED Light will flash to show that the PIR sensor is functioning properly.
4. MANUAL OVERRIDE FUNCTION
5. BLUE LED SENSOR INDICATOR
Turn the switch
OFF for 1 second
Turn the switch
back ON
