• Do not drag the mains cable along sharp
edges. Avoid jamming the mains cable, and do
not let the cable be suspended. Protect it from
heat.
• Use only extension cables that are in perfect
condition and designed for a voltage of at least
10 A.
• Do not use the appliance or pull the mains
cable immediately if:
– the appliance or mains cable is damaged
– the appliance is leaking
– there is cause for concern that it may be
damaged after it fell down or the like
Have the appliance repaired in such cases.
• Put the appliance on an even and solid base,
do not place it on hot surfaces such as stove
tops, hot plates or near open gas flames; it
may start to melt.
• Do not switch the appliance on when there is
no water inside, otherwise the pot or the grid
may be damaged.
• Always place the jars on the gridiron (not part
of the delivery) when preserving food.
• Pull the plug in the following cases:
– malfunction during operation
– before cleaning and maintaining it after use
• The appliance gets very heavy when it is fully
laden. Therefore, it should only be transported
when it is half full.
• Do not submerge the appliance in water for
cleaning it.
• We do not assume any liability for damages
caused by misuse, handling errors or
unprofessional repair. Besides, any warranty is
excluded for such cases.
Operation
Setting the boiler into operation
Before using it for the first time:
• Clean pot and lid thoroughly before using it
for the first time.
• Fill about 5 litres of water into the preserving
boiler and boil it out.
Note:
When first using the new appliance it
may exude a slight smell which has technical
reasons and does not give any cause for
concern.
How to operate the appliance properly:
• Always unwind the mains cable completely.
• Make sure that the mains cable does not get
into contact with the hot appliance during
operation.
Caution!
When filling in liquids do not exceed
a filling height of 4 cm below the rim of the pot
(corresponds to 23 litres in cooking mode).
Then close the lid. Otherwise there is danger
of scalds during cooking.
• Do not connect the appliance to the grounded
(SCHUKO) socket before you have filled it up.
• Do not switch the appliance on when there is
no water inside, otherwise the enamel or the
coated grid may get damaged. If you have –
despite all caution - switched the appliance on
without any water inside, wait for the appliance
to cool down again, before filling in the water,
otherwise there is a risk of scalds through
escaping steam.
• Let the condensation water drain into the pot
when removing the lid.
• Avoid transporting the fully laden appliance
as it is very heavy then – danger of injury.
Drain the appliance before transporting it or
skim some liquid off.
• After using the appliance pull the plug from
the socket and let the appliance cool down.
• Use the cable retainer and the plug holder
at the bottom to store the cable after use.
