HND-F215
page 16
HND-F215 K07/0522
Cyclic Logger Function: "Func CYCL"
Data sets that can be stored: 5400
One data set consists of: measuring value channel 1 - 6
The cycle time is set during "Device configuration".
Please Note: During long time recordings we suggest to use a
mains adapter (HND-Z002).
Start logger recording:
Press "Store"-key (key 6) for 2 seconds to start recording. Then .St.XXXX. will be
displayed for a short time for every logging; XXXX representing the number of the
data set 1..5400.
If the logger memory is full a warning triangle will be shown on the
display:
(warning triangle permanently shown, cyclic display of "LoGG FuLL"
and the current measuring value)
Stop logger recording:
Press "Store"-key (key 6) for a short time to stop recording. You will then be
asked to acknowledge again:
recording to be stopped
recording to be continued
Use the keys "
" (key 2) or "
" (key 5) to make your selection. Use "Quit"-key
(key 6) to acknowledge your selection.
Please note: If you try to switch off the instrument in the cyclic
recording mode you will be asked once again if the recording is to
be stopped. The device can only be switched off after the recording
has been stopped as the Auto-Power-Off-function is deactivated
during recording.
Delete data in logger memory:
Press "Store"-key (key 6) for 2 seconds to display the selection for deleting data,
if any, in the logger memory:
delete all data sets
do not delete (= cancel
procedure
Use the keys "
" (key 2) or "
" (key 5) to make your selection. Use "Quit"-key
(key 6) to acknowledge your selection.
