HOW TO ASSEMBLE THE HANDLE TUBE
To assemble the handle tube (6) you need two 7/16 wrenches.
TP MODELS
1.
Before assembling the handle tube (6) be sure the handle clamp (12) is positioned with the hole for the tube facing the motor (See fig. A).
2.
Slide the handle tube (6) through the handle clamp (12) hold the yoke (16) vertical and insert the tube over the yoke (See fig. A).
3.
Turn the handle tube (6) so the insert “Koblenz Industrial” faces the motor, align the holes on the tube and the yoke, and place the two screws (13) in
the holes with the heads toward the wheels. (See fig. A).
4.
Place the safety nuts (14) on the screws with the flat part facing the screw, turn them manually until they get hard, then hold the head with one
7/16 wrench and tight the nut with the other wrench as far as it can go. (See fig. A).
5.
Move the handle release lever (8) down on the lock position, and turn the pressure adjusting knob (11) as far as it goes. (See fig. B).
6.
Place the handle release lever (8) up on the release position and tighten the pressure adjusting knob (11) 1/4 more.
7.
Place the handle release lever (8) down again, and try tilting the machine over the rear wheels pulling down the handle (6), if the handle clamp
(12) slips over the tube (6), move the handle release lever (8) up to the release position, and turn the adjusting knob (11) 1/4 more.
8.
Repeat these steps until the handle clamp (12) does not slip when trying to tilt the machine.
9.
Connect the motor cables (9 and 10) making sure the insulating jacket is over the connectors.
RM & DP MODELS
1.
Before assembling the handle tube (6) be sure the handle clamp (12) is positioned with the hole for the tube facing the motor (See fig. C).
2.
Slide the handle tube (6) through the handle clamp (12) hold the yoke (16) vertical and insert the tube over the yoke (See fig. C).
3.
Turn the handle tube (6) so the insert “Koblenz Industrial” faces the motor, align the holes on the tube and the yoke, and place the two screws (13) in
the holes with the heads toward the wheels. (See fig. C).
4.
Place the safety nuts (14) on the screws with the flat part facing the screw, turn them manually until they get hard, then hold the head with one
7/16 wrench and tighten the nut with the other wrench as far as it can go. (See fig. C).
5.
Tighten the adjusting knob (8A) clockwise at a desired handle position until the handle clamp (12) does not slip when trying to tilt the machine.
6.
Connect the motor cables (9 and 10) making sure the insulating jacket is over the connectors.
For customer service contact your distributor or call 1.800.548.57.41
(8A) Adjusting knob
untighten
tighten
TP MODELS
RM & DP MODELS
(11) Pressure
adjusting knob
(6) Handle tube
(12) Handle clamp
(8) Handle release lever
Lock position
(Down)
Fig. B
Fig. D
(6) Handle tube
(11) Pressure
adjusting knob
(12) Handle clamp
(14) Safety Nut 1/4”
(13) Screw 1/4”
(16) Yoke
Fig. A
(13) Screw
(14)
Safety nut
(6) Handle tube
(12) Handle
clamp
(16) Yoke
Fig. C
4
