Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING
THE VENT OPENING.
•
Decide the location of the venting pipe from
the hood to the outside. Refer to Figure 1.
•
A straight, short venting run will allow the
hood to perform more efficiently.
•
Try to avoid as many transitions, elbows,
and long run as possible. This may reduce
the performance of the hood.
•
Temporarily wire the hood to test for proper
operation before installing.
•
Important: Peel protective film off the
hood (if any).
•
For installing under the cabinet with
recessed bottom, attach 4-inch wide wood
filler strips (not included) on each side.
Refer to Figure 2.
•
Using reference on Page 13 and 14 to
measure and create access opening for
electrical wires and exhaust under the
cabinet {refer to Vent Option Installation on
7}. Refer to Figure 3.
•
Using reference on Page 13 and 14 to
position the mounting screws (not included)
underneath the cabinet. Refer to Figure 4.
Install Lights before mounting hood
To install the light fixture:
-
Insert the light fixture into the socket
and turn it clockwise to secure the light
fixture.
Figure 1
Figure 2
Figure 3
Figure 4
