26
Instructions manual |
www.grupotemper.com
KPF-01
Power harmonic clamp meter
AC CURRENT measurement
1.
Switch the function knob to A~ position;
2. Pull the trigger to open the clamp, and then clip a wire which is to be
tested; the measured current value will be automatically shown on LCD
3. Press MODE button to show harmonics percentage on LCD, and the total
harmonic distortion ratio F and r will be cyclically displayed.
4.
Press ▲/▼ button to display value of each measurement of the harmonic.
5.
press MAX/MIN button to view Max or Min value
Test of single-phase circuit
1. Clip the clamp on the test wire of the power supply or load. If the user
needs to measure a certain phase of the 3-phase circuit, then the clamp
should clip on the wire of the same phase.
2.
switch the function switching knob to KW/Wposition, select
corresponding input sockets from V1 or COM terminal and insert the test
wire
3. After it is correctly connected, you can measure single-phase power
(active power, power factor, apparent power, passive power, voltage,
current, phase angle, peak value of voltage and current, and frequency):
4. The meter will carry out automatic measurement and display active power,
N
3
2
1
m