33
Instructions manual |
www.grupotemper.com
KMD 04
Digital multimeter
DC/AC Current
Warning
Do not measure current when voltages might exceed 250V to avoid
blowing the fuses which can lead to,personal injury or damage to the
meter.
Current ra
nges are: 400.0μA, 4000.0μA, 40.00mA, 400.0mA, 10.00A.
To measure current:
1. Turn off power to circuit and discharge all capacitors.
2.
Turn the rotary switch to the μA, mA or A position.
3. Press
to switch between DC/AC modes.
4.
Connect the red test lead to the μAmA input jack if measured current is
less than 400mA, the A input jack for measurements above 400mA and
the black test lead to the COM jack.
5. Break the circuit and connect the leads in series across the break with the
red lead at the higher voltage side and the blck lead on the lower voltage
side.
6. Turn on power to the circuit and read the measured current on the display.
If the display shows OL the measured value has exceed the selected
range. Move the rotary switch to the next higher current position.
Specifications
General specifications
Safety Rating:
CAT III, 600V; pollution degree II
Operating altitude:
<2000m
Operating Temperature/
Humidity:
0°C to 40°, <80% RH
Storage Temperature/
Humidity:
-10°C to 60°C, <70% RH, remove battery
Temperature coefficient:
0.1 x accuracy/ºC(>18ºC or <28ºC)
Max. Input between terminals
and earth ground:
600V DC or AC rms
