KCTE-80
Thermal Imager
www.grupotemper.com
6-Before You Start
6.1-How to Charge the Battery
Before you use the Thermal Imager for the first time, charge the battery for a minimum of one and one-half
hours. The battery status shows on the four-segment charge indicator.
To charge the battery, use follow before:
1-
Connect the ac power adapter into an ac wall outlet and connect the dc output to the Thermal Imager‟s ac
power socket, the charge light is on. The battery indicator becomes “
”le
the battery charges with the ac power adapter.
2-
Charge until the charge indicator becomes
, the charge light is off .
3-
Disconnect ac power adapter when the battery is full charged.
Note
Make sure that the Thermal Imager is near room temperature before you connect it to the charger. Do not
charge in hot or cold areas. When you charge in extreme temperature, battery capacity may be decreased.
6.2-Power On and Off
To turn the Thermal Imager on, push the Power
Button. When Thermal Imagers power on, Push and
hold the Power
Button for two seconds, turn the Thermal Imager off.
Note
The thermal Imager needs sufficient warm-up time for the most accurate temperature measurements and best
image quality. This time can often vary by environmental conditions. It is best to wait a minimum of 10 minutes if
the most accurate temperature measurement is very important to your application.
6.3-Desktop
The Desktop is as follow:
